53. How to match code for the New Wireless Camera to connect with NVR?

If your camera has a reset button, please use the following method to match code the camera.

blob.png

Before match code please delete the corresponding channel  to spare a channel out for a new camera, then you can match and add new camera into the channel.

1526625690798368.png

Match code the camera, you need to put the camera next to the NVR

1. Please put the camera next to the NVR, and connected the camera to the power supply

2. Right click mouse--go to "Wifi add", as below picture shows

3. It will automatically search and add cameras

4. A few seconds later the picture will be displayed on the screen

5. Click "Exit" after all cameras are connected

blob.png1526625415628436.png


If you have been match code for this camera before, but now it is disconnected  (“IPC Disconnected”)

1. Please put the camera next to the NVR, and connected the camera to the power supply

2. Please go to "Video Manage" and delete the "IP disconnected" camera from below.

1526626314287753.png

3. Press the camera's reset button for 13-15 seconds (the button next to the camera's power cord) and wait about 2 minutes. The camera automatically restarts.

blob.png

4. Right click mouse--go to "Wifi add", as below picture shows

1526625395123785.png1526625415628436.png

5. It will automatically search and add cameras

6. A few seconds later the picture will be displayed on the screen

7. Click "Exit" after all cameras are connected